Removal Procedure
WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the knee bolster. Refer to Knee Bolster Replacement (With SLT) or Knee Bolster Replacement (Without SLT) .
- Remove the steering column shroud. Refer to Steering Column Shroud Replacement .
- Put the steering column in the uppermost tilted position.
- Remove the tilt spring (1) from the steering column (2) using the following procedure:
- Pry up the tilt spring (1) until a bulge occurs and most of the tension is removed.
- Secure the tilt spring (1) with locking pliers.
- Continue prying the tilt spring (1) until the tilt spring disengages from the posts on the steering column (2) and from the steering column tilt head (3).
- Remove the spring guide (1) from the tilt spring (2).
WARNING:
The tilt spring and the spring guide are under pressure. The tilt spring and the spring guide may become a projectile. Secure the spring with locking pliers during removal. Secure the spring with locking pliers during installation. Bodily injury may result during removal and installation of the tilt spring and the spring guide. Always use caution during removal and installation of the tilt spring and the spring guide.