LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1552 (Steering Wheel And Steering Column) >> Repair Instructions >> Steering Column Tilt Spring Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Put the steering column in the uppermost tilted position.
    2. Fig 1: View Of Tilt Spring & Guide
    GM1858834Courtesy of GENERAL MOTORS CORP.
  2. Install the spring guide (1) to the tilt spring (2).
    3. Fig 2: View Of Steering Column, Tilt Head & Spring
    GM1858852Courtesy of GENERAL MOTORS CORP.
    WARNING: The tilt spring and the spring guide are under pressure. The tilt spring and the spring guide may become a projectile. Secure the spring with locking pliers during removal. Secure the spring with locking pliers during installation. Bodily injury may result during removal and installation of the tilt spring and the spring guide. Always use caution during removal and installation of the tilt spring and the spring guide.
  3. Install the tilt spring (1) onto the steering column (2) using the following procedure:
    1. Install the tilt spring (1) onto the post on the steering column tilt head (3).
    2. Install the tilt spring (1) onto the post on the steering column (2).
    3. Remove the locking pliers.
  4. Install the steering column shroud. Refer to Steering Column Shroud Replacement .
  5. Install the knee bolster. Refer to Knee Bolster Replacement (With SLT) or Knee Bolster Replacement (Without SLT) .
scientia non olet · About LEMON Manuals