LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1550 (Heating, Ventilation, And Air Conditioning) >> Repair Instructions >> Blower Motor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. If equipped, remove the sound insulator panel. Refer to Instrument Panel Insulator Replacement (With RPO SLT) or Instrument Panel Insulator Replacement (Without RPO SLT) .
  2. Remove the blower motor insulating cover screws.
  3. Disconnect the electrical connector from the blower motor.
  4. Remove the blower motor insulating cover.
    5. Fig 1: Disengaging Blower Motor
    GM382501Courtesy of GENERAL MOTORS CORP.
  5. Pull the retaining tab down while turning the blower motor counterclockwise in order to disengage the blower motor from the heater/ventilation module.
    6. Fig 2: View Of Blower Motor
    GM382496Courtesy of GENERAL MOTORS CORP.
  6. Remove the blower motor.
scientia non olet · About LEMON Manuals