LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1550 (Heating, Ventilation, And Air Conditioning) >> Repair Instructions >> Blower Motor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Blower Motor
    GM382496Courtesy of GENERAL MOTORS CORP.
  1. Install the blower motor.
    2. Fig 2: Turning Blower Assembly Clockwise
    GM382498Courtesy of GENERAL MOTORS CORP.
  2. Install the blower motor to the heater/ventilation module. Turn the blower assembly clockwise until the retaining tab locks into place.
  3. Install the blower motor insulating cover.
  4. Connect the electrical connector to the blower motor.
    5. CAUTION: Refer to Fastener Caution .
  5. Install the blower motor insulating cover screws and tighten to 1.6 N.m (14 lb in).
  6. If equipped, install the sound insulator panel. Refer to Instrument Panel Insulator Replacement (With RPO SLT) or Instrument Panel Insulator Replacement (Without RPO SLT) .
scientia non olet · About LEMON Manuals