Air Conditioning Compressor Bracket Replacement (HP2)

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Air Conditioning Compressor Bracket (HP2)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Remove the air conditioning compressor. Refer to Air Conditioning Compressor Replacement (LLY/LMM) or Air Conditioning Compressor Replacement (LU3) or Air Conditioning Compressor Replacement (LY2, LY5, LH6, L76, L92 and LMG) or Air Conditioning Compressor Replacement (HP2) . Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle . Remove the engine shield. Refer to Engine Shield Replacement . Remove the oil pan slid plate. Refer to Oil Pan Skid Plate Replacement (2500/3500 with RPO NZZ) . Remove transmission cooler bracket.
1	A/C Compressor Bracket Bolt CAUTION: Refer to Fastener Caution . Tighten: 50 N.m (37 lb ft)
2	A/C Compressor Bracket Bolt (Qty: 2) Tighten: 50 N.m (37 lb ft)
3	A/C Compressor Bracket Bolt (Qty: 3) Tighten: 50 N.m (37 lb ft)
4	A/C Compressor Bracket