Air Conditioning Accumulator Replacement (Non-HP2)

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Air Conditioning Accumulator (Non-HP2)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Recover the refrigerant. Refer to Refrigerant Recovery and Recharging (Non-HP2) or Refrigerant Recovery and Recharging (HP2) .
1	Suction Hose Nut CAUTION: Refer to Fastener Caution . Tip: Large A/C compressor hose to A/C evaporator. Tighten: 16 N.m (12 lb ft)
2	A/C Suction Hose
3	Sealing Washer Tip: Remove and discard sealing washer. Refer to Air Conditioning System Seal Replacement .
4	Accumulator Mounting Bracket Nut Tighten: 16 N.m (12 lb ft)
5	Accumulator Nut Tighten: 16 N.m (12 lb ft)
6	Sealing Washer Tip: Remove and discard sealing washer. Refer to Air Conditioning System Seal Replacement .
7	Accumulator Tip: Replacement service accumulators are shipped dry (no PAG oil). Add proper amount of oil to system before operating. Refer to Refrigerant System Specifications (Non-HP2) .