Rear Fender Clearance Lamp Replacement

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rear Fender Clearance Lamp

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Reach inside the rear fender and wheelhouse in order to disconnect the electrical connector for the rear fender lamp from the main chassis harness. Disengage the retainer securing the connector to the pick up box panel brace. From inside the wheelhouse push inward on the locking tab for the lamp assembly and push the lamp outward from the fender. Remove the lamp and electrical harness.
1	Rear Fender Clearance Lamps Tip: The amber lens is installed to the front of the rear fender and the red lens is installed at the rear of the rear fender.

Callout

Component Name

Preliminary Procedure

Reach inside the rear fender and wheelhouse in order to disconnect the electrical connector for the rear fender lamp from the main chassis harness.
Disengage the retainer securing the connector to the pick up box panel brace.
From inside the wheelhouse push inward on the locking tab for the lamp assembly and push the lamp outward from the fender.
Remove the lamp and electrical harness.

Rear Fender Clearance Lamps
Tip: The amber lens is installed to the front of the rear fender and the red lens is installed at the rear of the rear fender.