LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1548 (Lighting System) >> Diagnostic Information and Procedures >> Hazard Lamps Malfunction >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON, observe the scan tool Hazard Lamp Switch parameter while turning the hazard lamp switch ON and OFF. The reading should change between Active and Inactive.
    • If the parameter does not change between the commanded states, refer to the Circuit/System Testing.
  2. Observe the right and left turn signal lamps while turning the hazard lamp switch ON and OFF. The right and left turn signal lamps should flash ON and OFF while the hazard lamp switch is ON and remain OFF when the hazard lamp switch is OFF.
  3. Command the Lamp Test ON and OFF with a scan tool. The left and right turn signal indicators should turn ON and OFF when changing between the commanded states.
    • If the left and right turn signal indicators illuminate during the test, replace the BCM.
    • If the left and right turn signal indicators do not illuminate during the test or remain illuminated at all times, replace the instrument cluster.
scientia non olet · About LEMON Manuals