Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Install the sunshade to the vehicle from the passengers side.

Fig 1: View Of Sunshade End & Bracket Notch

Courtesy of GENERAL MOTORS CORP.

Insert the end of the sunshade (1) to the driver side bracket (2) notch.

Fig 2: Removing/Installing Sunshade From Bracket Notch

Courtesy of GENERAL MOTORS CORP.

Insert the sunshade (1) to the passengers side bracket (2) notch.

Fig 3: Turning Sunshade Cam

Courtesy of GENERAL MOTORS CORP.

Turn the sunshade cam (2) until it is aligned with the bracket (3) notch.
Install the sunshade.

Fig 4: Sunshade Cam Locking Hole

Courtesy of GENERAL MOTORS CORP.

Remove the suitable tool (1) from the sunshade cam locking hole (2).
Ensure that the sunshade cam (2) is fully seated in the bracket (3) and the sunshade slides smoothly.
Install the sunroof window. Refer to Sunroof Window Replacement (Extended Cab) or Sunroof Window Replacement (Crew Cab) .
Verify the operation of the sunshade.