Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Sunroof Opening Trim Finish Lace (Extended Cab)

Courtesy of GENERAL MOTORS CORP.

Position the end of the sunroof finishing lace at the center rear of the sunroof opening.

Fig 2: Pushing Finishing Lace Onto Track Assembly Flange

Courtesy of GENERAL MOTORS CORP.

Push the finishing lace (2) onto the track assembly flange (1) until fully seated around the sunroof opening.
Pull the finishing lace draw cord toward the sunroof opening. Remove the cord from the periphery of the opening.
Ensure that the finishing lace (2) is properly seated over the outer surface of the headliner (3).