Front Seat Center Latch Side Belt Replacement

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Front Seat Center Latch Side Belt

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
WARNING: Refer to SIR Warning . WARNING: In order to prevent accidental deployment and the risk of personal injury, do not dispose of an undeployed inflatable restraint seat belt pretensioner as normal shop waste. Undeployed seat belt pretensioners contain substances that could cause severe illness or personal injury if their sealed containers are damaged during disposal. Use the following deployment procedures to safely dispose of an undeployed seat belt pretensioner. Failure to observe the following disposal methods may be a violation of federal, state, or local laws. Preliminary Procedure Remove the driver seat. Refer to Front Seat Replacement - Bucket . Remove the jack stowage cover. Refer to Jack Stowage Cover Replacement . Remove the rear window lower trim. Refer to Rear Window Lower Garnish Molding Replacement (Ext Cab/Crew Cab w/A48) or Rear Window Lower Garnish Molding Replacement (Ext Cab/Crew Cab w/o A48) or Rear Window Lower Garnish Molding Replacement (Regular Cab) . Remove the rear inner panel carpet. Refer to Body Rear Inner Panel Carpet Replacement (Regular Cab) .
1	Front Center Seat Belt Anchor Plate Bolt CAUTION: Refer to Fastener Caution . Tighten: 43 N.m (32 lb ft)
2	Front Center Seat Shoulder Belt Guide
3	Front Center Seat Belt Retractor Nut (Qty: 2) Tip: Position carpet in order to access nuts. Tighten: 43 N.m (32 lb ft)
4	Front Center Seat Shoulder Belt Retractor Assembly Tip: Disconnect electrical connector.