LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1545 (Seat Belt System) >> Diagnostic Information and Procedures >> Seat Belt Indicator Circuit Malfunction - Passenger >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: When removing connectors, inspect for damage or corrosion. Damage or corrosion in the following requires repair or replacement of the appropriate component/connector:
  • The SDM
  • The SDM wiring harness connector
  • The seat belt buckle
  • The seat belt buckle wiring harness connector

Passenger Seat Belt Switch Circuit Malfunction

  1. Ignition OFF, disconnect the harness connector at the passenger seat belt switch.
  2. Ignition OFF, test for less than 10 ohms between the low reference circuit terminal B X1 and ground.
    • If greater than the specified range, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the SDM.
  3. Ignition ON, verify the scan tool Passenger Seat Belt Switch parameter is Unbuckled.
    • If not the specified value, test the signal circuit terminal A X1 for a short to ground. If the circuit tests normal, replace the SDM.
  4. Install a 3A fused jumper wire between the signal circuit terminal A X1 and the low reference circuit terminal B X1. Verify the scan tool Passenger Seat Belt Switch parameter is Buckled.
    • If not the specified value, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the SDM.
  5. If all circuits test normal, test or replace the seat belt buckle assembly.

Passenger Seat Belt Indicator Circuit Malfunction

  1. Ignition OFF, disconnect the harness connector at the inflatable restraint I/P module indicator.
  2. Have some sit in the passenger seat with the seat belt unbuckled. Ignition ON, test for less than 10 ohms between the low reference circuit terminal 5 and ground.
    • If greater than the specified range, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the IPC.
  3. Install a 3A fused jumper wire between the signal circuit terminal 4 and the low reference circuit terminal 5. Verify the scan tool Passenger Seat Belt Switch parameter is Unbuckled.
    • If not the specified value, test the signal circuit for a short to ground or an open/high resistance.
  4. If all circuits test normal, test or replace the inflatable restraint I/P module indicator.
scientia non olet · About LEMON Manuals