LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1545 (Seat Belt System) >> Diagnostic Information and Procedures >> Seat Belt Indicator Circuit Malfunction - Driver >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the seat belt switch.
  2. With the seat belt buckled, test for infinite resistance between the signal circuit terminal A and the low reference terminal B.
    • If not the specified range, replace the seat belt switch.
  3. With the seat belt unbuckled, test for less than 2 ohms of resistance between the signal circuit terminal A and the low reference terminal B.
    • If greater than the specified range, replace the seat belt switch.
scientia non olet · About LEMON Manuals