LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1543 (Instrument Panel Trim And Console Trim) >> Repair Instructions >> Instrument Panel Compartment Door Lock Cylinder Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Depressing Retainer Tumbler Through Poke Hole
    GM641756Courtesy of GENERAL MOTORS CORP.
  1. Remove the instrument panel compartment latch. Refer to Instrument Panel Compartment Door Latch Replacement (With RPO SLT)  or Instrument Panel Compartment Door Latch Replacement (Without RPO SLT) .
  2. Position the instrument panel compartment latch fork bolt in the up position.
  3. Insert the key into the instrument panel compartment lock cylinder.
  4. Rotate the instrument panel compartment lock cylinder clockwise to the 3 o'clock position with the key.
  5. With the key in position, apply a light load and depress the retainer tumbler through the poke hole at the right hand side of the instrument panel compartment latch.
    6. Fig 2: Rotating Key
    GM641556Courtesy of GENERAL MOTORS CORP.
  6. Rotate the key until the instrument panel compartment lock cylinder rotates to about the 5 o'clock position.

    This will line up the notch at the rear of the instrument panel compartment lock cylinder with the tab in the instrument panel compartment latch housing.

    7. Fig 3: Identifying I/P Compartment Door Lock Cylinder
    GM641536Courtesy of GENERAL MOTORS CORP.
  7. Remove the instrument panel compartment lock cylinder from the instrument panel compartment latch by pulling on the key.
scientia non olet · About LEMON Manuals