Instrument Panel Carrier Support Replacement (Without RPO SLT)

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Instrument Panel Carrier Support (Without RPO SLT)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Remove the instrument panel lower trim panel assembly. Refer to Instrument Panel Lower Trim Panel Replacement . Remove the body control module bracket. Refer to Body Control Module Bracket Replacement .
1	Instrument Panel Carrier to HVAC Duct Screws (Qty 2) CAUTION: Refer to Fastener Caution . Tighten: 2 N.m (18 lb in)
2	Instrument Panel Carrier Support Bolt (Qty: 7) Tighten: 22 N.m (16 lb ft)
3	Instrument Panel Carrier Support Assembly Procedure Note location and routing of the instrument panel wiring harness prior to removal of the instrument panel carrier support assembly to ensure proper reinstallation. Disconnect the wiring harness from the instrument panel carrier support assembly. With the aid of an assistant, remove the instrument panel carrier support assembly from the vehicle. If replacing the instrument panel carrier support assembly, transfer all necessary components.