Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exhaust Gas Recirculation Coolant Hoses/Pipes

Courtesy of GENERAL MOTORS CORP.

Inspect EGR cooling hose (4) and replace as necessary.

Fig 2: Upper EGR Cooler Pipe And Bolt

Courtesy of GENERAL MOTORS CORP.

CAUTION: Refer to Fastener Caution .

Position the EGR cooler pipe and hose (3) to the engine.
Tighten the lower bolt (1) to 9 N.m (80 lb in).

Fig 3: Exhaust Gas Recirculation Coolant Hoses/Pipes

Courtesy of GENERAL MOTORS CORP.

Install the EGR cooler pipe hose (4) to the EGR cooler tube and reposition the EGR cooler pipe clamp (3).
Tighten the clamp bolt (2) to 9 N.m (80 lb in).
Fill the cooling system. Refer to Cooling System Draining and Filling (Vac-N-Fill) or Cooling System Draining and Filling (Static Fill) .