Rear Spoiler Replacement (Sierra Silverado)

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Rear Spoiler Replacement (Sierra Silverado)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Endgate Spoiler Assembly Procedure Ensure to close the end gate prior to installation of the spoiler. The part and surface should be 50-70°F (10-21°C) prior to installation. The vehicle should remain inside for one hour after assembly to allow adhesive to develop sufficient bond strength. Release the adhesive backed liner and position the spoiler inside the end gate edge. Roll the spoiler outward over the end gate securing the adhesive tape to the endgate. Completely wet-out the entire surface of the spoiler to the end gate.

Callout

Component Name

Endgate Spoiler Assembly

Procedure

Ensure to close the end gate prior to installation of the spoiler.
The part and surface should be 50-70°F (10-21°C) prior to installation.
The vehicle should remain inside for one hour after assembly to allow adhesive to develop sufficient bond strength.
Release the adhesive backed liner and position the spoiler inside the end gate edge.
Roll the spoiler outward over the end gate securing the adhesive tape to the endgate.
Completely wet-out the entire surface of the spoiler to the end gate.