Hood Rear Molding Replacement (Chevrolet HD)
WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| 1 | Hood Emblem Tip: Gently release the two clips securing the emblem to the rear hood molding. |
| 2 | Hood Rear Molding Screw (Qty: 2)
CAUTION:
Refer to Fastener Caution
.
Tighten:: 1.5 N.m (13 lb in) |
| 3 | Hood Rear Molding Tip: Gently pry the hood molding upward, in order to release the seven retainers from the hood panel. |