Hood Front Molding Replacement (Chevrolet HD)

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Hood Front Molding Replacement (Chevrolet HD)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Release, open and support the hood in order to access the two under hood fasteners.
1	Hood Front Molding Nut (Qty: 2)
2	Hood Front Molding Procedure Release the hood molding eight retainers from the front hood edge. Position the locator tab first into the hood panel center hole followed by the remaining retainers. Using the palm of the hand, secure the retainers by pushing above each retainer until secured to the hood panel. Install and secure both outer hood molding nuts.

Callout

Component Name

Preliminary Procedure:
Release, open and support the hood in order to access the two under hood fasteners.

Hood Front Molding Nut (Qty: 2)

Hood Front Molding

Procedure

Release the hood molding eight retainers from the front hood edge.
Position the locator tab first into the hood panel center hole followed by the remaining retainers.
Using the palm of the hand, secure the retainers by pushing above each retainer until secured to the hood panel.
Install and secure both outer hood molding nuts.