Door Body Side Molding Replacement (GMC)

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Door Body Side Molding (GMC)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Rear Side Door Molding Procedure Use a strip of masking tape on the topside of the molding to mark the position of the molding prior to removing the old molding for replacement. The part and surface should be 21°C (70°F) prior to installation. The vehicle should remain 21°C (70°F) for one hour after assembly to allow adhesive to develop sufficient bond strength. Using a J 25070 Heat Gun in a circular motion, warm the rear side door molding prior to removal. Carefully clean the body panel thoroughly prior to bonding the new rear body side molding to the door. Ensure the rear door is in the closed position prior to installing the new rear side door moldings. Remove the protective liner from the backside of the molding adhesive tape. Ensure full adhesion of the molding to the door using the palm of the hand with a clean dry towel working from the rear edge of the rear door to the front, down the entire molding. Remove the masking tape from the rear door.

Callout

Component Name

Rear Side Door Molding

Procedure

Use a strip of masking tape on the topside of the molding to mark the position of the molding prior to removing the old molding for replacement.
The part and surface should be 21°C (70°F) prior to installation. The vehicle should remain 21°C (70°F) for one hour after assembly to allow adhesive to develop sufficient bond strength.
Using a J 25070 Heat Gun in a circular motion, warm the rear side door molding prior to removal. Carefully clean the body panel thoroughly prior to bonding the new rear body side molding to the door.
Ensure the rear door is in the closed position prior to installing the new rear side door moldings.
Remove the protective liner from the backside of the molding adhesive tape.
Ensure full adhesion of the molding to the door using the palm of the hand with a clean dry towel working from the rear edge of the rear door to the front, down the entire molding.
Remove the masking tape from the rear door.