LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1409 (Engine Mechanical - 6.6L (5 Of 5)) >> Repair Instructions - Off Vehicle (4 Of 4) >> Crankshaft Balancer Installation >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Crankshaft Balancer & Bolt
    GM1334816Courtesy of GENERAL MOTORS CORP.
  1. Lightly lubricate the crankshaft balancer internal hub with engine oil.
  2. Install the crankshaft balancer to the crankshaft.
  3. Lightly lubricate the crankshaft balancer bolt with engine oil.
    4. NOTE: Refer to FASTENER CAUTION .
  4. Install the crankshaft balancer bolt and washer.

    Tighten: 

    1. Tighten the bolt to 100 N.m (74 lb ft) on the first pass.
    2. Tighten the bolt an additional 105 degrees.

  5. Remove the J 44643  . See Special Tools .
scientia non olet · About LEMON Manuals