LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1401 (Engine Mechanical - 6.6L (2 Of 5)) >> Repair Instructions - On Vehicle >> Oil Level Indicator Tube Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Oil Level Indicator Tube & Bolt
    GM1873233Courtesy of GENERAL MOTORS CORP.
  1. Install NEW O-ring seals onto the oil level indicator tube.
  2. Lightly lubricate the O-ring seals with engine oil.
  3. Install the oil level indicator tube.
    CAUTION: Refer to Fastener Caution .
  4. Install the oil level indicator tube bolt at the indicator tube bracket.

    Tighten:  Tighten the bolt to 21 N.m (15 lb ft).

  5. Install the starter motor. Refer to Starter Replacement (6.6L) .
  6. Install the exhaust manifold. Refer to Exhaust Manifold Replacement - Right Side (6.6L) .
  7. Install the oil level indicator.
scientia non olet · About LEMON Manuals