LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1401 (Engine Mechanical - 6.6L (2 Of 5)) >> Repair Instructions - On Vehicle >> Engine Oil Level Sensor and/or Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: When routing the oil level sensor wire, ensure that the wire is routed along the side of the oil pan.
    Fig 1: View Of Oil Level Sensor, Clip, Bolt & Oil Pan Mating Surface
    GM663624Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  1. Install the oil level sensor (1) and bolt (2) and tighten to 9 N.m (80 lb in).
  2. Install the oil level sensor clip (3).
  3. Install the lower oil pan. Refer to Lower Oil Pan Replacement .
scientia non olet · About LEMON Manuals