LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1398 (Steering Linkage) >> Repair Instructions >> Steering Linkage Shock Absorber Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the engine shield, if equipped. Refer to Engine Shield Replacement .
    2. Fig 1: View Of Linkage Shock Absorber
    GM1862839Courtesy of GENERAL MOTORS CORP.
    NOTE: Discard the steering linkage shock absorber nut.
  2. Remove the steering linkage shock absorber nut (1) from the steering linkage shock absorber (2).
    3. Fig 2: View Of Steering Damper Ball Stud, Relay Rod & J 24319-B
    GM397364Courtesy of GENERAL MOTORS CORP.
  3. Remove the steering linkage shock absorber from the relay rod using puller J 24319-B  .
    4. Fig 3: View Of Linkage Shock Absorber Bolt & Nut
    GM1862840Courtesy of GENERAL MOTORS CORP.
    NOTE: Discard the steering linkage shock absorber nut.
  4. Remove the steering linkage shock absorber bolt (2) and nut (3).
  5. Remove the steering linkage shock absorber (1) from the vehicle.
  6. Inspect the following parts:
    • The steering linkage shock absorber for leaks and damage
    • The steering linkage shock absorber bolt for damage or corrosion
scientia non olet · About LEMON Manuals