LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1398 (Steering Linkage) >> Repair Instructions >> Pitman Arm Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the pitman arm onto the steering gear.
    2. Fig 1: View Of Steering Gear & Pitman Arm
    GM1862648Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  2. Install a new pitman arm washer (2) and nut (1).

    Tighten:  Tighten the nut to 250 N.m (184 lb ft).

  3. Remove the steering gear from the vise.
  4. Install the steering gear. Refer to Steering Gear Replacement (HP2) , Steering Gear Replacement (Recirculating Ball Without LMM) , Steering Gear Replacement (Hydraulic Rack and Pinion) or Steering Gear Replacement (LMM) .
  5. Adjust the front toe. Refer to Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment .
scientia non olet · About LEMON Manuals