LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1398 (Steering Linkage) >> Repair Instructions >> Idler Arm Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Do not attempt to free the ball stud by using a pickle fork or wedge type tool, because seal or bushing damage could result. Use the proper tool to separate all ball joints.
  1. Remove the engine shield, if equipped. Refer to Engine Shield Replacement .
    2. Fig 1: View Of Idler Arm & Relay Rod
    GM1862657Courtesy of GENERAL MOTORS CORP.
    NOTE: Discard the idler arm nut.
  2. Remove the idler arm nut (3) from the idler arm (1).
  3. Separate the idler arm (1) from the relay rod (2).
    4. Fig 2: View Of Outer Tie Rod Assembly & J 24319-B
    GM643351Courtesy of GENERAL MOTORS CORP.
  4. Remove the idler arm from the relay rod using puller J 24319-B  .
    5. Fig 3: View Of Idler Arm, Bolts & Nuts
    GM340442Courtesy of GENERAL MOTORS CORP.
  5. Remove the idler arm bolts (3) and the nuts (1) at the vehicle frame.
  6. Remove the idler arm (2) from the vehicle.
scientia non olet · About LEMON Manuals