LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1392 (Engine Mechanical - 4.3L) >> Repair Instructions - On Vehicle >> Oil Level Indicator Tube Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra and 2009 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Applying Sealant & Installing Oil Level Indicator Tube & Bolt
    GM188009Courtesy of GENERAL MOTORS CORP.
  1. Apply sealant around the indicator tube 13 mm (0.5 in) below the tube bead. Refer to Adhesives, Fluids, Lubricants, and Sealers  for the correct part number.
  2. Install the indicator tube. Rotate the oil level indicator tube into position.
    CAUTION: Refer to Fastener Caution .
  3. Install the indicator tube bolt.

    Tighten:  Tighten the bolt to 12 N.m (106 lb in).

    4. Fig 2: Locating Oil Level Indicator
    GM330580Courtesy of GENERAL MOTORS CORP.
  4. Install the right exhaust manifold. Refer to Exhaust Manifold Replacement - Right Side (4.3L) .
  5. Install the oil level indicator.
scientia non olet · About LEMON Manuals