Installation Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra and 2009 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating Flywheel Weights (Manual Transmission)

Courtesy of GENERAL MOTORS CORP.

NOTE: Flywheel weights of the same length must be installed into the NEW flywheel in the same location as the old weights were in the old flywheel.

Note the position of the old flywheel weights and install the NEW flywheel weights as required.
A properly installed flywheel weight will be flush or slightly below flush with the face of the flywheel.

Fig 2: View Of Flywheels

Courtesy of GENERAL MOTORS CORP.

Install the flywheel (1 or 2).
Align the flywheel locator hole to the flywheel locator pin.

Fig 3: Identifying Flywheel Bolt Tightening Sequence

Courtesy of GENERAL MOTORS CORP.

CAUTION: Refer to Fastener Caution .

Install the flywheel bolts and tighten in the sequence shown to 100 N.m (74 lb ft).
Install the automatic transmission. Refer to Transmission Replacement .