LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1392 (Engine Mechanical - 4.3L) >> Repair Instructions - Off Vehicle >> Valve Rocker Arm Cover Installation - Right Side

Valve Rocker Arm Cover Installation - Right Side

WARNING: This page is about a different car, the 2009 GMC Sierra and 2009 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Rocker Arm Cover & Gasket
    GM328573Courtesy of GENERAL MOTORS CORP.
    NOTE: Do not reuse the valve cover gasket or the valve rocker arm cover bolt grommets.
  1. Install the NEW valve rocker arm cover gasket into the groove of the valve rocker arm cover.
  2. Install the NEW valve rocker arm cover bolt grommets into the valve rocker arm cover.
    3. Fig 2: View Of Valve Rocker Arm Cover (Right)
    GM480524Courtesy of GENERAL MOTORS CORP.
  3. Install the valve rocker arm cover onto the cylinder head.
    4. Fig 3: View Of Valve Rocker Arm Cover Bolts (Right)
    GM328568Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  4. Install the valve rocker arm cover bolts and tighten to 12 N.m (106 lb in).
scientia non olet · About LEMON Manuals