Component Testing
WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
You must perform the Circuit/System Testing in order to verify the integrity of the exhaust pressure differential sensor circuits before proceeding with the Component Testing.
- Ignition OFF, remove the exhaust differential pressure sensor.
- Install a 3A fused jumper wire between the 5V reference circuit terminal 3 and the corresponding terminal of the exhaust pressure differential sensor. Install a jumper wire between the low reference circuit terminal 1 of the exhaust differential pressure sensor and ground.
- Connect a DMM between the signal circuit terminal 2 of the exhaust differential pressure sensor and ground.
- Ignition ON, with the J 23738-A
or the J 35555
, slowly apply vacuum to the sensor while observing the voltage on the DMM. See Special Tools
. The voltage should vary and transition smoothly without any spikes or dropouts.
- If the voltage is erratic, replace the exhaust differential pressure sensor.