Circuit/System Description

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

The particulates in the exhaust gases are collected by the diesel particulate filter (DPF). When the filter becomes saturated with particulates, they are incinerated by a regeneration process. The regeneration process increases the exhaust gas temperature, warming the diesel oxidation catalyst (DOC) first, then warming the DPF. The engine control module (ECM) monitors the system with inputs from two exhaust gas temperature (EGT) sensors 1 and 2 and an exhaust differential pressure sensor.

The ECM will command an active regeneration base on a calculated soot model. The soot model calculations are based on the following information:

Distance since last DPF regeneration
Fuel used since last DPF regeneration
Engine run time since last DPF regeneration
Exhaust differential pressure sensor values

As soot loading continues to increase, differential pressure increases. When differential pressure exceeds a calibrated threshold, this diagnostic will run and fail.