LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1385 (Engine Controls And Fuel - 6.6L - DTC P1448 To DTC P2510) >> DTC P2002 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify that DTCs P003A, P0047, P0048, P0101, P0201-P0208, P0234, P0299, P02A1, P02A5, P02AD, P02B1, P02B5, P02B9, P029D, P0300-P0308, P0401, P0402, P046C, P0545, P0546, P2032, or P2033 are not set.
  2. Verify that leaks do not exist in the exhaust system. Refer to Exhaust Leakage .
  3. Engine running at idle, perform the following:
    1. Engine coolant temperature greater than 80°C (176°F).
    2. Command the EGR solenoid with a scan tool to 35 percent.
    3. Perform several accelerator pedal sweeps by rapidly depressing the accelerator pedal to wide open throttle (WOT) and returning the pedal to the at rest position, allowing the engine to return to idle speed for 5 seconds, while observing the exhaust from the tailpipe. There should be very light or no smoke visible from the tailpipe.
    • If a heavy black smoke is observed from the vehicles tailpipe, replace the particulate filter assembly.
scientia non olet · About LEMON Manuals