LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1383 (Hybrid Controls - DTC P0AFF To DTC P16F9) >> DTC P16F2 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2009 GMC Sierra and 2009 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clear the DTC information.
  2. Turn the ignition OFF for 1 minute.
  3. Turn the ignition ON.
  4. Test for correct operation of the Direction IMS in every range selection. Hold the selector in each gear position for at lease 2 seconds. Refer to Typical Scan Tool Data .
    • If the Direction IMS operation does not match the logic table proceed with Circuit/System Testing.
  5. Retest for DTC P16F2.
    • If the DTC resets, program the PIM with the latest software version and recheck for DTCs. IF the DTC resets after programming or if the PIM already contains the latest software version, replace the PIM.
scientia non olet · About LEMON Manuals