Circuit/System Testing
WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the harness connector at the TCM.
- Ignition OFF, test for less than 3 ohms between ground circuit terminal 9 and battery ground and between ground circuit terminal 69 and battery ground.
- If greater than the specified range, repair the affected ground circuit.
- Ignition OFF, verify that a test lamp illuminates between the battery B+ circuits terminal 10 and ground and terminal 70 and ground.
- If the test lamp does not illuminate, repair the affected B+ circuit.
- If circuits test normal, replace the TCM.
NOTE:
You must perform the Circuit/System Testing first.