LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1376 (Engine Controls And Fuel - Hybrid (Hp2) 6.0L (LFA) - DTC P0231 To DTC P069E) >> DTC P0650 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2009 GMC Sierra and 2009 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, open the hood to disable the Auto-Stop function. Refer to Hybrid Modes of Operation Description .
  2. Ignition ON, verify the scan tool hood position parameter displays Open.
  3. Ignition ON, verify that the instrument panel cluster (IPC) warning indicators are illuminated.
    • If the IPC warning indicators are not illuminated, test the ignition circuit for a sort to ground or an open/high resistance. If the circuit tests normal and the ignition circuit fuse is open, replace the IPC.
  4. Ignition OFF, disconnect connector X1 at the ECM.
  5. Ignition ON, verify the MIL is not illuminated.
    • If the MIL is illuminated, inspect the MIL control circuit for a short to ground. If the circuit tests normal, replace the IPC.
  6. Ignition ON, verify that the MIL illuminates with a 3A fused jumper between the MIL control circuit, ECM terminal X1-12, and ground.
    • If the MIL does not illuminate, test the MIL control circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the ECM.
scientia non olet · About LEMON Manuals