Circuit/System Verification
WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition ON and fuel cap removed, verify that the FTP sensor parameter is between 1.3-1.7 volts.
- If not within the specified range, go to FTP Sensor in Circuit/System Testing.
- Install the fuel cap.
- With the engine running, the EVAP canister vent solenoid valve open and the EVAP canister purge solenoid valve commanded to 100 percent, the fuel tank vacuum should not increase to more than 11 inches H2O.
- If the fuel tank vacuum is greater than the specified range, go to Restriction in Circuit/System Testing.
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.