Component Testing
WARNING: This page is about a different car, the 2009 GMC Sierra and 2009 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Using the J 44152
and the J 35616
, measure the resistance between the ignition 1 voltage circuit and the TCC Solenoid valve circuit. The resistance should be between 21-33 ohms for the TCC Solenoid valve.
- If the resistance is not within the specified range, remove the affected solenoid.
- Disconnect the wiring harness connector from the affected solenoid. Measure the resistance of the affected control circuit. The resistance should be between 21-33 ohms for the TCC Solenoid valve.
- If the resistance is not within the specified range, replace the affected solenoid.