Component Testing
WARNING: This page is about a different car, the 2009 GMC Sierra and 2009 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the AT inline 20-way connector at the transmission.
- Install the J 44152 jumper harness (20 pins), on the transmission side of the AT inline 20-way connector. See Special Tools .
- Test for 10-15 ohms of resistance between the control terminal U and the ignition terminal E of the transmission.
- If not within the specified range, test the circuits for a short to ground or an open/high resistance. If a circuit is shorted or open replace the internal transmission harness, if the circuits test normal, replace the TCC PWM solenoid.
- Test for infinite resistance between each terminal and the transmission housing/case.
- If not the specified value, test the circuits for a short to ground or an open/high resistance. If a circuit is shorted replace the internal transmission harness, if the circuits test normal, replace the TCC PWM solenoid.