LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1369 (Engine Controls And Fuel - 6.6L - DTC P0016 To DTC P02E7) >> DTC P003A >> Component Testing >> TC Vane Position Sensor

TC Vane Position Sensor

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, remove the TC vane position sensor.
  2. Connect the harness connector to the TC vane position sensor.
  3. Ignition ON, observe the scan tool TC Vane Position Sensor voltage while slowly depressing the plunger at the end of the TC Vane Position Sensor. The voltage should decrease smoothly from approximately 4.9-0.2 V.
    • If the TC Vane Position Sensor voltage drops out or spikes, replace the TC vane position sensor. It is normal for the TC Vane Position voltage to quickly return to approximately 4.9 V as the plunger reaches its fully depressed position.
scientia non olet · About LEMON Manuals