Conditions for Running the DTC: P0133
WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- DTCs P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P0201, P0202, P0203, P0204, P0205, P0206, P0207, P0208, P0220, P0222, P0223, P0442, P0443, P0446, P0449, P0455, P0496, P1516, P2101, P2119, P2135, P2176 are not set.
- The Engine Coolant Temperature (ECT) Sensor parameter is more than 60°C (140°F).
- The Intake Air Temperature (IAT) Sensor parameter is more than -40°C (-40°F)
- The Ignition 1 Signal parameter is between 10-18 volts.
- The Fuel Level Sensor parameter is more than 10 percent.
- The Engine Run Time parameter is more than 160 seconds.
- The Engine Speed parameter is between 1,200-3,000 RPM.
- The Barometric (BARO) Pressure parameter is more than 70 kPa.
- The Mass Airflow (MAF) Sensor parameter is between 20-55 g/s.
- The Loop Status parameter is Closed.
- The Throttle Position (TP) Indicated Angle parameter is more than 5 percent.
- DTC P0133 runs once per drive cycle when the above conditions are met.