LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1366 (Engine Controls And Fuel - 4.8L, 5.3L, 6.0L, 6.2L - DTC P0010 To DTC P0230) >> DTC P0106 >> Component Testing >> Erratic Signal Test

Erratic Signal Test

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, remove the MAP sensor.
  2. Install a 3A fused jumper wire between the 5-volt reference circuit terminal C and the corresponding terminal of the MAP sensor.
  3. Install a jumper wire between the low reference terminal A of the MAP sensor and ground.
  4. Install a jumper wire at terminal B of the MAP sensor.
  5. Connect a DMM between the jumper wire from the terminal B of the MAP sensor and ground.
  6. Ignition ON, with the J 23738-A  or J 35555  , slowly apply vacuum to the sensor while observing the voltage on the DMM. The voltage should vary between 4.9-0.2 volts without any spikes or dropouts.
    • If the voltage is erratic, replace the MAP sensor.
scientia non olet · About LEMON Manuals