LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1360 (Wiring Systems And Power Management - DTC B0005 To DTC B1475) >> DTC B1475 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON, verify DTC B1475 is set as current.
    • If DTC B1475 is not set as current, operate the vehicle within the Conditions for Setting the DTC.
    2. IMPORTANT: When cycling the ignition, keep ignition OFF for 5 seconds before checking for current DTC.
  2. Disconnect each of the following components one at a time. The components may be disconnected in any order. After each component is disconnected, cycle the ignition and verify DTC B1475 remains set as current.
    • Driver window switch (with RPO A31)
    • Passenger window switch (with RPO A31)
    • Sliding rear window switch (with RPO A48)
    • Mobile radio relay A (with RPO 9L4)
    • Sunroof module (with RPO CF5)
    • If DTC B1475 does not remain set as current, test or replace the last component that was disconnected.
  3. With all components disconnected, cycle the ignition and verify DTC B1475 is not set as current.
    • If DTC B1475 remains set as current, test the accessory voltage circuit for a short to ground. If the circuit tests normal, replace the BCM.
scientia non olet · About LEMON Manuals