Circuit/System Verification
WARNING: This page is about a different car, the 2009 GMC Sierra and 2009 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Inspect for DTC P1AE7.
- If the DTC is set, the loss of isolation has occurred within the drive motor generator battery. Diagnose this concern first. Refer to DTC P1AE6 or P1AE7 .
- Inspect for DTCs P0A78, P0A79, P0BFD, P0BFE, P0C01, or P0C04.
- If any of the DTCs are set, the loss of isolation has occurred within the 3-phase components. Diagnose this concern first. Refer to Diagnostic Trouble Code (DTC) List - Vehicle .
- Clear the DTC information.
- Turn the ignition OFF for 1 minute.
- Turn the ignition ON.
- Operate the vehicle within the Conditions for Running the DTC.
- Retest for DTCs P1AF0 and P1AF2.
IMPORTANT:
DTC P1AE7 must test and pass before performing this diagnostic procedure.