LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1355 (Automatic Transmission - ALLISON - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> Turbine Shaft Bushing Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Cross Sectional View Of Proper Turbine Shaft Bushing Installation
    GM1217079Courtesy of GENERAL MOTORS CORP.
  1. Install a new bushing (2) onto J 43791  (1). See Special Tools .
  2. Drive the bushing into turbine shaft (3) until the bushing is seated to specifications.

    Specification:  The bushing installed depth measurement is flush to 0.25 mm (0.010 in) below the inner turbine shaft surface.

scientia non olet · About LEMON Manuals