Installation Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Prop Shaft Front Slip Yoke Oil Seal

Courtesy of GENERAL MOTORS CORP.

Using J 43782 install the prop shaft front slip yoke oil seal (1). See Special Tools .
Make sure the oil seal is installed to the correct depth below the rear face of the low and reverse clutch housing, 2WD (2).
Specification: The rear seal installed depth is 4.55-5.35 mm (0.179-0.211 in) below the rear face of the low and reverse clutch housing, 2WD.