Installation Procedure
WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Install the vehicle speed sensor O-ring (3) onto the output speed sensor (OSS) (2).
- Apply J 36850: lubricant to the O-ring (3).
- Install the OSS (2) into the low and reverse clutch housing, 2WD.
- Install the vehicle speed sensor bolt (1) into the low and reverse clutch housing, 2WD. Tighten the bolt to 12 N.m (108 lb in).
CAUTION:
Refer to Fastener Caution
.