LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1355 (Automatic Transmission - ALLISON - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> Output Shaft Bushing Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Output Shaft Bushing
    GM1217034Courtesy of GENERAL MOTORS CORP.
  1. Install a new output shaft bushing (2) onto J 43791  (1). See Special Tools .
  2. Using J 43791  , drive the bushing into the output shaft (3) until J 43791  (1) is seated to specification. See Special Tools .

    Specification:  Make sure the bushing is pressed flush to 0.25 mm (0.01 in) below the output shaft surface.

scientia non olet · About LEMON Manuals