LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1355 (Automatic Transmission - ALLISON - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> Intermediate Carrier Bushing Replacement >> Replacement Procedure

Replacement Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: The preferred method for removing/installing the intermediate carrier bushing is to use J 43785  and a press. See Special Tools . If a press is not available, use J 43785  and universal driver J 8092  . See Special Tools .
    Fig 1: Removing Intermediate Carrier Bushing Using J 43785 & J 8092
    GM1217020Courtesy of GENERAL MOTORS CORP.
  1. Position the intermediate carrier assembly (3) on wooden blocks on the press with the external splines facing up.
  2. If the bushing will be removed with out a press, install the short end of J 43785  (2) onto J 8092  (1). See Special Tools .
  3. Using J 43785  (2), press or drive the bushing (4) out of the carrier (3). See Special Tools .
    4. Fig 2: Installing Intermediate Carrier Bushing
    GM1217019Courtesy of GENERAL MOTORS CORP.
  4. Position the intermediate carrier assembly (4) on wooden blocks on the press with the external splines facing down.
  5. If the bushing will be installed without a press, install the long end of J 43785  (2) onto J 8092  (1). See Special Tools .
  6. Install a new bushing (3) onto J 43785  (2). See Special Tools .
  7. Using J 43785  (2), press or drive the bushing into of the carrier until J 43785  (2) seats. See Special Tools .
scientia non olet · About LEMON Manuals