LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1355 (Automatic Transmission - ALLISON - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> Input Carrier Bushing Replacement >> Replacement Procedure

Replacement Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Input Carrier Assembly
    GM1407206Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The preferred method for removing/installing the input carrier bushing is to use J 43781  and a press. See Special Tools . If a press is not available, use J 43781  and J 8092  universal driver. See Special Tools .
  1. Position the input carrier assembly (3) on the press with the external splines facing up.
  2. If the bushing will be removed without a press, install the short end of J 43781  (2) onto J 8092  (1). See Special Tools .
  3. Using J 43781  , press or drive the bushing (4) out of the carrier. See Special Tools .
    4. Fig 2: Installing Input Carrier Assembly Bushing
    GM1217719Courtesy of GENERAL MOTORS CORP.
  4. If the bushing will be installed without a press, install the long end of J 43781  (2) onto J 8092  (1). See Special Tools .
  5. Install a new bushing (3) onto J 43781  (2). See Special Tools .
  6. Using J 43781  , press or drive the bushing into the carrier until J 43781  (2) seats. See Special Tools .
scientia non olet · About LEMON Manuals