Removal Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of J 24204-2 & J 44530 Installed In Transmission Case

Courtesy of GENERAL MOTORS CORP.

CAUTION: Refer to 3-5 Reverse Clutch Backing Plate Rivet Damage Caution .

Install J 24204-2: assembly (1) and J 44530: compressor (2) into the transmission case. Make sure that J 24204-2: assembly does not touch the gear thrust plate rivets (6) on the 3rd, 5th, and reverse clutch backing plate assembly.
Compress the piston return spring assemblies (5) until a gap is visible below the retaining rings (3 and 4).

NOTE: The outer 2-6 clutch retaining ring is thinner and larger in circumference compared to the inner low and reverse clutch retaining ring.

Remove the low and reverse clutch retaining ring (3).
Remove the 2-6 clutch retaining ring (4).
Remove (1) and J 24204-2: assembly (2) from the transmission case.

Fig 2: Identifying 2-6 Clutch Backing Plate

Courtesy of GENERAL MOTORS CORP.

Remove the 2-6 clutch backing plate (1).

Fig 3: View Of 2nd Clutch Plates & Piston Return Spring Assemblies

Courtesy of GENERAL MOTORS CORP.

Remove five 2-6 clutch fiber plates (1) and four 2-6 clutch steel plates (2).
Remove, as a unit, the 2-6 clutch spring plate (4) and 3 piston return spring assemblies (3).

Fig 4: Identifying Piston Return Spring Assemblies

Courtesy of GENERAL MOTORS CORP.

NOTE: The piston return spring assemblies snap off.

Remove 3 piston return spring assemblies (1) from the 2-6 clutch spring plate (2).

Fig 5: View Of Input Internal Ring Gear

Courtesy of GENERAL MOTORS CORP.

Remove the input internal ring gear (1).